interference level

A major finding was the strong frequency dependent interference level.

Quickly she explained about the shifting frequencies and the interference levels.

Figure 10shows the frequency dependence of the interference level.

The increase of the number of users will contribute to the interference level.

A complicated selection process followed, and about 90 stations were deemed to have the greatest need based on interference levels.

This power level is defined as the interference level.

The extremely low interference level at 1500 MHz should be noted.

Particularly low interference levels were observed in the frequency range around 1500 MHz.

Both tested implants showed the same interference level.

The access-points automatically selects a frequency channel with low interference level.

The geodesic interference level is a common attribute of all the mutually interfering layers.

This will prevent other more efficient data flows, since there is a maximum allowed interference level in the cell, and reduce the throughput.

He ran through a few switch checks and noted the readings on an auxiliary readout: The interference level was high, but not yet critical.

Several variants of the Speech Interference Level are in use:

The frequency increment was reduced to 1 MHz only in bands where low interference levels were observed.

For a user that suffers from high path loss, the power control will cause high interference level to signals from other users.

SAIC-enabled mobiles can work in high interference levels.

Speech Interference Level, an acoustical parameter.

(The FCC defines what interference levels are deemed to be "harmful".)

In CDMA spread spectrum cellular networks, the cost may be the required energy per bit in the transmit power control (the increased interference level).

Speech Interference Level (SIL) is an acoustical parameter calculated from sound pressure levels measured in octave bands.

The ITREL-III returned to normal operation after reducing the transmit power below the interference level.

Tests with broadband dipoles and different power levels showed that the output signal of the ITREL-III abruptly failed (inhibition) when the interference level was exceeded.

Other types of neurological stimulators could also have a frequency dependent interference level but with interference levels below the emissions of mobile phones at other frequencies.

The algorithm for multi-directional deposition using geodesic interference level attribute was introduced by Rajeev Dwivedi and Radovan Kovacevic in 2005, at the Research Center for Advanced Manufacturing.