heat of combustion

This is the same as the thermodynamic heat of combustion.

It certainly hadn't been harmed by the heat of combustion.

It is sometimes called the heat of combustion.

Because of their high strain, the heat of combustion for these small rings is elevated.

The heat of combustion is conventionally measured with a bomb calorimeter.

The heat of combustion of the methanol keeps the wire hot enough to do the job.

See Heat of Combustion for a more thorough treatment of this topic.

A small factor contributes to the correction of the total heat of combustion is the fuse wire.

This compares well with the modern published heat of combustion for carbon of 2.13 kcal/g.

The difference in heat of combustion is 22.7 kJ mol.

The bomb calorimeter is a common type used to determine the heat of combustion of such substances as fuel and food.

Therefore, trans isomers have a less exothermic heat of combustion, indicating higher thermochemical stability.

This recovery of the heat of combustion significantly increased the efficiency of the turbine engine.

Before the bomb can be used to determine heat of combustion of any compound, it must be calibrated.

Angle strain destabilizes a molecule, as manifested in higher reactivity and elevated heat of combustion.

As they are directly exposed to the radiant heat of combustion, they have a high evaporative capacity relative to their size.

Net heat of combustion min.

Experimentally, strain energy is often determined using heats of combustion which is typically an easy experiment to perform.

Air and the gaseous materials absorb the heat of combustion, and become less dense than the surrounding air.

The Hückel delocalization energy correlates with the experimental heat of combustion.

The actual heating value when the water formed does not condense is the net heat of combustion and can be as much as 10 percent less.

The heat of combustion, in combination with decay heat, would probably drive "borderline aged" fuel into a molten condition.

The air expands greatly from the heat of combustion, and flows through another set of blades, turning them as it passes through.

On the other hand, if we look at the heat of combustion of double or triple bond containing compounds, we might find the reverse.

At a constant volume the heat of combustion of a petroleum product can be approximated as follows: