groundsill
ground plate

Chattel houses are set on blocks or a groundsill rather than being anchored into the ground.

Some parishioners were buried in one of the chantry chapels, beneath the 'groundsill'.

The residential wing's upper floor is built with exposed timber framing, a decorated groundsill, several chest- and neck-high railings and an oriel window.

- Ground plates are laid by keeping apart from the building about 10 meters.

The ionized particles, following the negative electric field created by the power supply, move to the grounded plates.

To control volume, the performer's other hand acts as the grounded plate of another variable capacitor.

Ground plates or tripods are typically used for remote cameras placed on the ground.

Further discoveries in 1984 included better-preserved windows and ground plates and pivot blocks for doors.

Other names are ground plate, ground sill, groundsel, and mud sill.

The ionized particles then are attracted to the positively grounded plate, creating a layer of caked on dust particles.

These are a safety measure; if an excessive charge is applied to the delicate gold leaves, they will touch the grounding plates and discharge before tearing.

The 4CX250B tetrodes used a grounded plate (anode) due to forced aircooling requirements.

- Minimum Ground Clearance: 54 mm (Flat Ground Plate)

The Grand Nagus gingerly picked up the tool, holding it from the extreme edge, and unlocked the frequency clamps at each corner of the transmuter's grounding plate.

The performer's hand acts as the grounded plate (the performer's body being the connection to ground) of a variable capacitor in an L-C (inductance-capacitance) circuit, which is part of the oscillator and determines its frequency.

At frequencies used by radiofrequency ablation devices, energy is transferred primarily by conductive (ohmic) heating, where current is generated through the movement of charge from the ablation probe to the electrical ground plate via the path of least resistance.

With each cycle, charge was drawn from the Earth and added to C. After a suitable number of cycles, the grounded plate D would be removed, and the electrostatic potential on C would rise to approximately the potential of A multiplied by the number of operations.

Category E: alluvial surface layer grounds (very low quality soil) The type of foundations is selected according to the type of ground; for instance, in the case of homogeneous rock formations connected plinths are selected, while in the case of very low quality grounds plates are chosen.