cable housing

All four teenagers safely reach the cable housing inside the bridge support frame.

The cable housing was centered, and the roof angled slightly down away from it.

However, the arms are longer, with the cable housing attached to one arm and the cable to the other.

The cable housing attaches like that of a side-pull brake.

Cables should always move freely through all cable housings and the guides that hold them in place.

Now take the two cable housings around the inside of the back bend (as per the photos already sent) until they are both pointing forward.

She looked around and saw an access hatch less than twenty meters ahead, on their side of the monorail, below the cable housing.

Charlie tripped over the hump of a deck-level cable housing.

Dual parachute release systems with the yellow or white jacket do not need the cable housing tip described above.

Comes with a cable housing stopper for cantilever brakes.

He glared at the old Hylar, and lounged pointedly against his cable housing.

Cable housings that protect your cables can break, corrode or clog up over time.

These arms have extensions on one side, one attached to the cable, the other to the cable housing.

The cable housing chewed his neck.

Coloured wheels and brake cable housing.

The original, standard Bowden cable housing consists of a close-wound helix of round or square steel wire.

Cutting standard cable housing: When replacing the outer cable housing, measure it against the old one so that you get the correct length.

The group reach the top after 12 minutes and stop to rest in the cable housing inside the bridge support frame, it is unclear how they manage to get back down.

QBP also became the exclusive U.S. distributor for Jagwire, a Taiwan-based manufacturer of bicycle brake and derailleur components including pads, cables and cable housing.

Weak, disconnected, or mis-connected throttle return springs, worn shot-pump barrels, chafed cable housings, and cables which jump their tracks in the throttle-body crank can all cause similar acceleration problems.

Usually provision is made for adjusting the cable tension using an inline hollow bolt (often called a "barrel adjuster"), which lengthens or shortens the cable housing relative to a fixed anchor point.

This is totally the way to go if you like simplicity, the outer cable housing stops at the fork top bolt and the inner just runs down the steerer and out through an angled hole.

A good cable housing is hell to cut with pliers and you will almost certainly damage the ends of the housing, creating a crushed section which can hamper the smooth passage of the cable.

A light of hope was born in her eyes, but just as she parted her lips to speak there came a jerk on the tether line and then another, setting up a thrumming echo in the cable housing.

As a consequence, major bicycle manufacturers such as Schwinn and Raleigh installed Accu-Shift on low-end bikes using inventories of older freewheels, hubs, cables, cable housings, and chains from other manufacturers.